Traditional 2 Person Sauna w/Harvia Stone Heater
Free Living Co APPROVED! This is your Low-Tox Infrared Sauna Go To. The least toxic, lowest EMF radiation sauna on the market! Ships from Heavenly Heat!
GET 10% OFF by clicking this link 👇
Enjoy an authentic sauna experience with a 6kw Harvia stone heater for deep, traditional heat in a clean sauna, crafted without glues, plywood, or stains.
Buy yours today before it sells out again.
Free Shipping!
Dimensions:
Exterior: 59.1 in. Width / 43.3 in. Depth / 75 in. Height
Interior: 55.6 in. Width / 39.7 in. Depth / 71 in. Height
Weight: 441 pounds + traditional heater and rocks
Recommended two inch gap between the sauna and any walls or ceilings
2 Person Traditional Sauna Assembly Manual
Traditional Heater Installation Manual
KV60 Heater Installation Manual
100% Non-Resinous Canadian Hemlock Wood.
No Glues, Plywood, or Stains.
Premium Warranty:
10 Years for wood/carpentry and 6 years for electrical components including heaters.
Customizable Ventilation:
Our sauna vents can be opened or closed while sitting in the sauna. You can keep them closed to increase the heat-up speed and then open them to your liking during your sauna session.
Elevated Bench:
Even though our ventilation system is designed to move the hot air throughout the sauna, hot air still rises. Our elevated bench keeps you in the hottest part of the sauna.
8mm Tempered Glass:
Thick tempered glass provides phenomenal heat retention and an open, modern design.
Glass-Covered Chromotherapy Lighting:
Choose between 9 different light settings. Glass cover (no plastic).
Harvia KV-60-S Stone Heater + Sauna Rocks:
We strictly use the Harvia KV-60-S because of it’s performance and ease of use. The control knobs are near the top of the heater making it much easier to manipulate than when the knobs are on the bottom. Harvia is the most trusted name in Sauna Heaters.
Electrical:
Traditional Heater:
240V
Dedicated 30 Amp
Electrician Required
Harvia KV-60-S or FLB-60-S (controls built on heater)
KV60 & FLB60 needs a 2 pole 30 amp non-GFCI breaker.
Run (2) #10 copper wires + ground to heater.
Wires connect to heater terminals 1 and 2.
Make sure to run the thermostat wire up the face of the sauna wall. Sensor mounts a foot down from the ceiling and about a foot away from the side of the heater.
Sauna Lights:
110/120v
Standard US plug
GET 10% OFF 👇
Choose options